KARAKTERISTIK MATERIAL KOMPOSIT BERBASIS BATUAN BASALT DAN DROSS AL

Authors

  • Muhammad Al Muttaqii Indonesian Institute of Sciences
  • Fauzul Kurniajaya Universitas Malahayati
  • Agung Efrio Hadi Universitas Malahayati

DOI:

https://doi.org/10.21776/ub.jrm.2022.013.01.3

Keywords:

Basalt, Dross Al Komposit, Kampas rem, Kuat tekan, Absorpsi

Abstract

Basalt is one of the basic igneous rocks formed from the freezing process of magma on the earth's surface and has a very good grain size. This study aims to determine the characteristics of the composite basalt as initial data for the manufacture of brake linings. In this study, basalt was made into a composite with the composition of basalt and dross Al of 45:30%, 55:20%, 65:10% and polyester resin 25%. The material used has particle sizes of 100, 150, and 200 mesh. The materials were made by mixing for 5, 10, and 15 min. Then carried out the compaction process with a load of 2 tons with a holding time of 5 min. Next, the material was sintered at 150 oC for 2 h. The characteristics studied were compressive strength referring to ASTM D695-15 and Absorption referring to SNI 03-2105-2006. From the results of composite testing, the best characteristics were found in specimen 3, with a compressive strength value of 113.616 MPa and Absorption of 1.39%.

Author Biography

Muhammad Al Muttaqii, Indonesian Institute of Sciences

Research Center for Chemistry

References

FAISAL. “Karakteristik marshall campuran aspal beton AC-BC menggunakan material agregat basalt dengan aspal PEN. 60/70 dan tambahan parutan ban dalam bekas kendaraan roda 4â€. Jurnal Teknik Sipil Pascasarjana Universitas Syiah Kuala Vol. 3 No. 3. 2014.

ADI ATMIKA. “Karakteristik keausan kampas rem berbasis hybrid komposit epoxy-serbuk basaltâ€. 2015.

SUMA WIJAYA. “Charpy impact test pada kampas rem hybrid komposit phenolic resin matrik dengan penguat serbuk basalt-Alumina-kulit kerangâ€. Jurnal Energi dan Manufaktur., Vol. 9, No. 2. 2016.

AGUNSOYE J. O. The Development and Characterisation of Aluminium Dross-Epoxy Resin Composite Materials. Journal of Materials Science Research; Vol. 3, No. 2. 2014.

ADEOSUN, S. O. ET AL. ‘Physical and mechanical properties of aluminum dross’. Advances in Materials. 3(2), pp. 6–10. doi: 10.11648/j.am.20140302.11. 2014.

HAYGREET J.G, BOWYER, J.L. “Hasil hutan dan ilmu kayuâ€. Gajah Mada University, Jogjakarta. 1996.

Downloads

Published

2022-06-22

Issue

Vol. 13 No. 1 (2022)

Section

Articles

License

Copyright (c) 2022 Muhammad Al Muttaqii

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.