Pengaruh Campuran Bahan Bakar Biodiesel WCO - Diesel terhadap Karakteristik Api Hasil Pembakaran Spray Difusi pada Concentric Jet Burner
DOI:
https://doi.org/10.21776/ub.jrm.2021.012.02.22Keywords:
Biodiesel, WCO, Diffusion FlameAbstract
Biofuels from waste cooking oil (WCO) represent a sizable opportunity not only in terms of energy production but also as a way for sustainable development despite their low yield, higher viscosity, lengthy production time and cost. Alternatively, biodiesel can be blended at an appropriate blending ratio with convention diesel oils. The biodiesel and its blends is proved to give better emission characteristics than conventional diesel oils. This study aims to experimentally investigate the effect of the fuel blend on the combustion characteristics of  WCO biodiesel. The characteristic are the droplet size, flame height, flame width and temperature distribution. In this study, the blended fuel are B0 (Solar), B10, B20, B30, B40 and B100 (WCO biodiesel). Measurement and visualization of the combustion flame for each variation of the fuel mixture was were tested at different pressures, namely 4 bar and 5 bar. The experimental results show that the droplet size increases with increasing WCO concentration in the fuel; on the other hand, visualization and calculations show that the height and width of the flame of the fuel mixture decreases Observation on the temperature distribution shows that the WCO biodiesel mixture has the potential to increase the fire temperature at certain pointsReferences
EMARA, K., MAHFOUZ, A., MONEIB, H.A., EL-FATIH, A., EMARA, A., “Flame spectroscopy of waste tire oils and waste cooking oils blends using coaxial burner,†J. Energy Inst., vol. 93, no. 3, pp. 977–990, 2020.
LIU, H., ZHU, J., HU, Q., RAO, X. “Morganella morganii, a non-negligent opportunistic pathogen,†Int. J. Infect. Dis., vol. 50, pp. 10–17, 2016.
MKHIZE, N. M., VAN D, DANON, B., GÖRGENS, J. F. “Effect of temperature and heating rate on limonene production from waste tyre pyrolysis,†J. Anal. Appl. Pyrolysis, vol. 120, pp. 314–320, 2016.
MOBARAKI, N, AMIGO, J. M., “HYPER-Tools. A graphical user-friendly interface for hyperspectral image analysis,†Chemom. Intell. Lab. Syst., vol. 172, pp. 174–187, 2018.
PRIEUR, K., DUROX, D, SCHULLER, T. CANDEL, S., “A hysteresis phenomenon leading to spinning or standing azimuthal instabilities in an annular combustor,†Combust. Flame, vol. 175, pp. 283–291, 2017.
SENG-EIAD, S., JITKARNKA, S., “Untreated and HNO3-treated pyrolysis char as catalysts for pyrolysis of waste tire: In-depth analysis of tire-derived products and char characterization,†J. Anal. Appl. Pyrolysis, vol. 122, pp. 151–159, 2016.
ABOELAZAYEM, O., EL-GENDY, N.S., ABDEL-REHIM, A. A., ASHOUR, F., SADEK, M. A. “Biodiesel production from castor oil in Egypt: Process optimisation, kinetic study, diesel engine performance and exhaust emissions analysis,†Energy, vol. 157, pp. 843–852, 2018.
SENTHUR, P.S., ASOKAN, M. A., ROY, R., FRANCIS, S., SREELEKH, M.K. “Performance, combustion and emission characteristics of diesel engine fuelled with waste cooking oil bio-diesel/diesel blends with additives,†Energy, vol. 122, no. January 2018, pp. 638–648, 2017.
MAHFOUZ, A. “Effect of Waste Cooking - Diesel Oils Blends on Performance, Emissions and Combustion Characteristics of Industrial Oil Burner,†Int. J. Res. Appl. Sci. Eng. Technol., vol. V, no. IX, pp. 1264–1274, 2017.
MAHFOUZ, A., MONEIB, H. A., EL-FATIH, A., EL-SHERIF, A. F., AYOUB, H. S., EMARA, A. “Comparative study among waste cooking oil blends flame spectroscopy as an alternative fuel through using an industrial burner,†Renew. Energy, vol. 159, pp. 893–907, 2020.
ATTIA, A. M. A., BELAL, B. Y., EL-BATSH, H. M., MONEIB, H. A. “Effect of waste cooking oil methyl ester – Jet A-1 fuel blends on emissions and combustion characteristics of a swirl-stabilized lean pre-vaporized premixed flame,†Fuel, vol. 267, no. October 2019.
DENG, S., ZHAO, P., MUELLER, M. E., LAW, C. K. “Flame dynamics in oscillating flows under autoignitive conditions,†Combust. Flame, vol. 168, pp. 75–82, 2016.
LIU, C., HUANG, L., DENG, T., JIANG, H., WU, P., LIU, P., DENG, J., LUO, Z., “Influence of bottom wall on characteristics of jet diffusion flames under cross-wind,†Fuel, vol. 288, no. November, p. 119661, 2021.
SAKTHIVEL, R., RAMESH, K., PURNACHANDRAN, R., MOHAMED S. “A review on the properties, performance and emission aspects of the third generation biodiesels,†Renew. Sustain. Energy Rev., vol. 82, no. 5, pp. 2970–2992, 2018.
ZHANG, H., XIA, X., GAO, Y., “Instability transition of a jet diffusion flame in quiescent environment,†Proc. Combust. Inst., vol. 000, pp. 1–8, 2020.
FAIZAL, E., WIDODO, S. A., SASONGKO, M. N. “Pengaruh Variasi Lip Thickness pada Nozzle Terpancung terhadap Karakteristik Api Pembakaran Difusi Concentric Jet Flowâ€. Jurnal Rekayasa Mesin. 7(2):13-20., 2016.
SASONGKO, M. N. “Pengaruh Prosentase Minyak Goreng Bekas terhadap Karakteristik pembakaran droplet biodieselâ€. Flywheel: Jurnal Teknik Mesin Untirta. 4(2):8-13. 2018.
SOM, S., AGGARWALS. K. “Effects of Primary Breakup Modeling on Spray and Combustion Characteristics of Compression Ignition Enginesâ€. Combustion and Flame.157(6):1179-1193. 2010.
WIRAWAN, I. K. G., GHURRI, A., SEPTIADI, W. N. “Distribusi Ukuran Droplet Bahan Bakar Minyak Jelantah Sepanjang Region Semburan Nosel Sederhanaâ€, Jurnal Mechanical. 9(1):16-21, 2018.
WAHYUDI, W., SARIP, S., SUDARJA, S., SUHATNO, H. “Unjuk Kerja Mesin Diesel Berbahan Bakar Campuran Biodiesel Jarak dan Biodiesel Jelantah,†JMPM (Jurnal Mater. dan Proses Manufaktur), vol. 3, no. 1, pp. 36–41, 2019.
XI, Z., FU, Z., HU, X., SABIR, S. W., JIANG, Y., “An investigation on flame shape and size for a high-pressure turbulent non-premixed swirl combustion,†Energies, vol. 11, no. 4, pp. 1–20, 2018.
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
