The Effect of Mass and Diameter of Waste Valves on the Efficiency of 3 inch Ram Hydraulic
DOI:
https://doi.org/10.21776/ub.jrm.2021.012.02.3Keywords:
Mass Valve Waste, Waste Valve Diameter, Hydraulic Pump EfficiencyAbstract
This study aim to analyze the effect of the mass and diameter of the waste valve on the efficiency of hydraulic pumps. This study method was an experiment on the specimens and analyzing the mathematical equations contained in the hydraulic pump theory. The data measured in this study were the flow of water in, discharge of wastewater, and discharge of water out. Independent variables in this study were the mass of the waste valve, namely 1.5 kg, 2.0 kg, 2.5 kg, 3.0 kg and the diameter of the waste valve was 2.0 inches, 2.25 inches, and 2.50 inches. While the dependent variable were the discharge and efficiency of the hydraulic pump. The results show that the mass of the waste valve and the diameter of the waste valve affected the efficiency of the hydraulic pump. The highest efficiency of the hydraulic pump occurred at a waste valve mass of 1.5 kg and a waste valve diameter of 2.5 inches which was 78.08%, and the lowest efficiency occurred at a mass of 3.0 kg waste valve and a 2.0-inch diameter of a waste valve which was 33. 56%.
References
BERLI PARIPURNA KAMIEL, NIKO PRASTOMO, BAMBANG RIYANTA, “Ekstraksi Parameter Statistik Domain Waktu Dan Domain Frekuensi Untuk Mendeteksi Kavitasi Pada Pompa Sentrifugal Berbasis Principal Component Analysis (Pca)â€, Rekayasa Mesin, eISSN 2477-6041, vol. 10, no. 2, pp. 165 – 176, 2019.
MUHAMAD JAFRI, GUSNAWATI, APRIYANTO BANAMTUAN, “Analisa Beda Tinggi Katup dan Variasi Diameter Pipa Inlet Terhadap Unjuk Kerja Pompa Hidram Ukuran Dua Inchiâ€, LJTMU, vol. 03, no. 01, hal. 71-76, 2016.
MUHAMAD JAFRI, ARIFIN SANUSI, “Analysis Effect of Supply Head and Delivery Pipe Length toward the Efficiency Hydraulic Ram 3 Inchesâ€, International Research Journal of Advanced Engineering and Science, Volume 4, Issue 2, pp. 263-266, DOI: 10.5281/zenodo.3153468, 2016.
FATAHI-ALKOUHI, R., LASHKAR-ARA, B., KERAMAT, A., “Determine the efficiency of hydraulic ram-pumps,†E-proceedings of the 36th IAHR World Congress, The Hague, the Netherlands pp. 1-7. 28 June – 3 July, 2015,
MATTHIAS INTHACHOT, SUCHARD SAEHAENG, JOHANNES F.J. MAX, JOHANNES MULLER, WOLFRAM SPREER, “Hydraulic Ram Pumps for Irrigation in Northern Thailandâ€, Agriculture and Agricultural Science Procedia, Vol. 5 pp. 107 – 114, 2015.
SAITO, S., DEJIMA, K., TAKAHASHI, M., HIJIKATA G., AND IWAMURA, T., “Effects of the Lift Valve Opening Area on Water Hammer Pump Performance and Flow Behavior in the Valve Chamber,†International Journal of Fluid Machinery and System (IJMFS), ISSN (Online): 1882-9554, Vol. 5, No. 3, pp 109-116, July-September 2012.
SAITO, S., TAKAHASHI, M., NAGATA, Y., AND DEJIMA, K., “Effects of the Geometry of Components Attached to the Drain. Valve on the Performance of Water Hammer Pumps,†International Journal of Fluid Machinery and System (IJMFS), ISSN (Online): 1882-9554, Vol. 4, No 4, pp 367-374 October-December 2011.
SCHILLER, E.J., “The Hydraulic Ram Pump (hydram),†: Its History, Operating Characteristics and Potential Usage: Proceedings of a Workshop on Hydraulic Ram Pump (Hydram) Technology, 29 Mei - 1 Juni, 1984.
MADE SUARDA, AINUL GHURRI, MADE SUCIPTA AND I GUSTI BAGUS WIJAYA KUSUMA, “Valve Diameter Optimization ofHydram Pump Waste’, BKSTM-Indonesia, Prosiding SNTTM XVI, hal. 14-18, Oktober 2017.
GAN SHU SAN DAN GUNAWAN SANTOSO, “Studi Karakteristik Volume Tabung Udara dan Beban Katup Limbah Terhadap Efisiensi Pompa Hydraulic Ramâ€. JURNAL TEKNIK MESIN Vol. 4, No. 2, pp. 81 – 87, 2002.
TEGUH IRAWAN, NOVA RISDIYANTO ISMAIL, SURIANSYAH, “Pengaruh volume tabung udara dan beban katup buang dengan Jarak katup delivery 2 cm terhadap kinerja pompa hidramâ€. Widya Teknika Vol. 24, No. 1, pp. 59 – 64, 2016.
SYAMSUL HIDAYAT, NOVA RISDIYANTO ISMAIL, SURIANSYAH, “Pengaruh Variasi Beban Dan Jarak Kerja Katup Buang Terhadap Efisiensi Pompa Hidramâ€. Widya Teknika Vol. 24 No. 2. ISSN 1411 – 0660: pp. 59 – 66, 2016.
HANAFIE, J., DE LONGH, H. Teknologi Pompa Hidraulik Ram, Pusat Teknologi Pembangunan Institut Teknologi Bandung, Bandung. 1979.
EKO SULISTIAWAN, ROMADHON TRI WAHYUDI, SETIA PRADANA, NAIF FUHAID, “Pengaruh Volume Tabung Udara dan Beban Katub Limbah Terhadap Efisiensi Unjuk Kerja Pompa Hidramâ€. PROTON, Vol. 5 No 2 / Hal 1-4, 2013.
MOHAMAD FAJRI, MUHAMAD JAFRI, ERICH U. K. MALIWEMU, “Pengaruh Diameter Katup Limbah dan Jarak antara Katup Limbah dengan Katup Penghantar terhadap Efisiensi Pompa Hidramâ€. LONTAR Jurnal Teknik Mesin Undana: Vol. 02, No. 01, pp. 55-60, 2015.
GATUT PRIJO UTOMO, ,KHOIRUL ABIDIN, “Analisa Pengaruh Panjang Pipa Galvanis Dan Diameter Bukaan Katup Terhadap Head Pompa Pada Pompa Hidramâ€, Mekanika Jurnal Teknik Mesin, Volume 1, No. 1, 2015.
YOSEF AGUNG CAHYANTA, INDRAWAN TAUFIK, “Studi terhadap prestasi pompa hidraulik ram dengan variasi beban katup limba’, Jurnal Ilmiah Teknik Mesin CAKRAM, Vol. 2 No. 2, pp. 92 –96, 2008.
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
