Desain dan Optimasi Injection Mold Sistem Slider pada Produk Stick T15

Authors

  • Lutfi Khoirul Miftakhul Ni'am Program Studi Teknik Mesin, Fakultas Teknik, Universitas Muhammadiyah Yogyakarta http://orcid.org/0000-0001-7950-5316
  • Cahyo Budiyantoro Program Studi Teknik Mesin, Fakultas Teknik, Universitas Muhammadiyah Yogyakarta
  • Muhammad Budi Nur Rahman Program Studi Teknik Mesin, Fakultas Teknik, Universitas Muhammadiyah Yogyakarta

DOI:

https://doi.org/10.21776/ub.jrm.2017.008.03.6

Keywords:

injection molding, slider, undercut, cooling

Abstract

The design of injection molding is the initial process to produce a large-scale product of plastic material which heated and injected into the mold. Design of the preform mold using the plastic material polyethylene terephthalate with the construction of the slider, so that the products which was made have undercut and can’t be made in the core section and cavity. The purpose of this design is to design the slider on the product preform. The software which used for this design using CATIA V5R19 and simulation software production using Autodesk Moldflow Insight 2016. The step on designing a unit injection mold in the preform includes several steps. The first step is identify the product, the calculation of the cooling and input the data calculation result to an moldflow. The second step is design construction slider and determine the mold material as well as calculating the construction mold. The third step is pour the results of the design in figure 2D. Based on the analysis results from moldflow obtained cooling optimal.i.e. the type of cooling series type 2, and if can be concluded construction of the mold said to be safe if the stress, the style and the determination  of material which occurs under the stress and style of permit.

Author Biography

Lutfi Khoirul Miftakhul Ni'am, Program Studi Teknik Mesin, Fakultas Teknik, Universitas Muhammadiyah Yogyakarta

Mahasiswa Teknik Mesin (Terakreditasi B), Universitas Muhammadiyah Yogyakarta (Terakreditasi A)

References

Brydson, J.A. 1999. PLASTICS MATERIALS Seventh Edition. London: Butterworth Heinemann. halm, 170-171.

Budiyantoro, Cahyo. 2009. Thermoplastik Dalam Industri. Surakarta: Teknika Media.

Jones, Peter. 2008. The Mould Design Guide. United Kingdom: Smithers Rapra.

Camaj, Michal. 2015. “Multy-cavity Injection Mold Designâ€. Master Thesis, Faculty of Technology, Thomas Bata University in Zlin.

Pindak, Martin. 2012. “Design of injection mold including cooling system optimizationâ€. Master Thesis, Faculty of Technology, Thomas Bata University in Zlin.

Nakazawa, Makoto. 2010. Mold Basic Design Textbook. Jakarta: IMDIA..

Goodship, Vannessa. 2004. Practical Guide to Injection Moulding. Germany: ARBURG Ltd.

Downloads

Published

2017-12-31

How to Cite

Ni’am, L. K. M., Budiyantoro, C., & Rahman, M. B. N. (2017). Desain dan Optimasi Injection Mold Sistem Slider pada Produk Stick T15. Jurnal Rekayasa Mesin, 8(3), pp. 155–165. https://doi.org/10.21776/ub.jrm.2017.008.03.6

Issue

Section

Articles