Analisis Perbandingan Tribometer Types dengan Variasi Material - Review
DOI:
https://doi.org/10.21776/ub.jrm.2015.006.02.3Keywords:
Tribometer, Thrustwasher, Block on Ring, Pin on Disk, Aluminium, Steel ST 40Abstract
There are many tribometers especially friction test to make a research and to develop many kind of materials. Three types of tribometer that common to use for friction test are thrustwasher, block on ring, and pin on disk. In this study, Alumunium and Steel ST 40 was used to investigate the wearness value. The load used in the pin is 24,81 kg/mm². The result showed that Aluminium have higher wearness value than Steel ST 40.
References
https://en.wikipedia.org/wiki/Tribometer
http://www.lehigh.edu/~intribos/facilities.html
Bezzazi M, Khamlichi A., Jabbouri A, Reis P, Davim JP (2007). Experimental characterization of Frictional behaviour of Clutch Facings using Pin-on-disk machine. Materials and Design. Elsevier Sci. Netherlands. 28(7): 2148-2153.
Hoglund,E.,1984. "Elastohydrodynamic Lubrication;Interferometric Measurements, Lubricant Rheology and Subsurface Stresses, Doctoral Thesis, Luleh University of Technology, Sweden, 32D,
Dowson, D. History of Tribology, Second edition, London: Professional Engineering Publishing, 1998.
Darmanto, Muhamad Thufik R. 2013 Analisis Keausan Alumunium Menggunakan Tribotester dengan Variasi Pelumas,Universitas Wahid Hasyim ,Semarang
Anang Rohadi, Imam Syafaat, 2012 Analisis Keausan Baja ST.40 Menggunakan Tribotester dengan Variasi Pelumas,Universitas Wahid Hasyim ,Semarang
Downloads
Published
Issue
Section
License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.