KAJIAN EKSPERIMENTAL PENGARUH PENGGUNAAN ELECTRONIC CONTROL UNIT AFTERMARKET PADA DAYA, TORSI, EMISI DAN KONSUMSI BAHAN BAKAR SEPEDA MOTOR 150CC
DOI:
https://doi.org/10.21776/jrm.v14i2.1276Keywords:
Motorcycle, Power, Torque, Fuel Consumption, Exhaust Emissions, Electronic Control UnitAbstract
To improve motorbike performance, simple modifications are often applied using an aftermarket Electronic Control Unit (ECU). However, scientific studies on this particular topic are still limited. Therefore, the purpose of this research is to examine the effect of the aftermarket Juken 5 ECU on the power, torque, emissions, and fuel consumption of the Yamaha R15-V3 bike. The results of the dynamometer testing showed that the motorcycle with the Juken 5 ECU experienced an average increase of 8.09 ± 1.30% in power and 7.79 ± 1.31% in torque, respectively, at 5500 – 11000 rpm. However, the concentrations of Carbon Monoxide and Hydrocarbon emissions also increased by 170% and 360%, respectively. Particulate emission measurements also revealed that the Juken 5 ECU usage resulted in a significant increase in particulate counts. Compared to the standard ECU, motorcycles equipped with the Juken 5 ECU produced 89% and 145% more particulates in the size range of 0.3 – 0.374 μm and 0.374 – 2.685 μm, respectively. The performance and emission data analysis results indicated that the increase in power and torque achieved by the Juken 5 ECU is simply due to more fuel being injected into the combustion chamber. This finding was supported by the results of fuel consumption testing, where using the aftermarket ECU increased motorcycle fuel consumption by 63.6%.
References
CNN, Sensus kendaraan di Indonesia, https://www.cnnindonesia.com/teknologi/20210203115349-384-601700/sensus-kendaraan-di-indonesia-lebih-dari-133-juta-unit. Diakses: Juni 2021.
Badan Pusat Statistik, Perkembangan jumlah kendaraan bermotor menurut jenis periode 2017-2019, https://www.bps.go.id/indicator/17/57/1/jumlah-kendaraan-bermotor.html. Diakses: Januari 2022.
Raharja, E., Sepeda motor jadi penyumbang terbanyak polusi udara, https://www.medcom.id/otomotif/motor/8N000qMN-sepeda-motor-jadi-penyumbang-terbanyak-polusi-udara. Diakses: Januari 2022.
Ismiyati, Marlita, D., Saidah, D., “Pencemaran udara akibat emisi gas buang kendaraan bermotor”, Jurnal Manajemen Transportasi & Logistik, v. 1, n. 3, pp. 241–247, Nov. 2014.
Wahyudi, N., “ Studi eksperimen pengaruh variasi perubahan sudut injektor pada system EFI terhadap performa motor 4 langkah”, Journal of Electrical Electronic Control and Automotive Engineering (JEECAE), v. 1, n. 1, pp. 47–52, Feb. 2017.
Reddy, K.V.M.K, Reddy, B.M., Reddy, K.C.S., Kartheek, P., Adarsh, T.S., “Comparative investigation of electronic fuel injection in two-wheeler applications: A review”, IOP Conference Series Materials Science and Engineering, v. 1116, n. 1, 012073, Apr. 2021.
Buthker, G.S., Automated vehicle electronic control unit (ECU) sensor location using feature-vector based comparisons, M.Sc. Thesis, Wright State University, Dayton, Ohio, United States, 2019.
Ilyas, S., Naveed, U., Khalid, J., "Improving fuel consumption using Electronic Fuel Injection Technology for low-powered Motorbike Engine", In: 2020 17th International Bhurban Conference on Applied Sciences and Technology (IBCAST), 236-243, Islamabad, Pakistan, 14-18 January 2020.
Syaka, D.R.B., Purwoko, A.T., Sopiyan, “Design and experiment of a prototype electronic control unit direct injection fuel system arduino-based for 2-stroke spark ignition engine”, Automotive Experiences, v. 5, n. 1, pp. 49-56, Nov. 2021.
Suarta, I.M., Sopan Rahtika, I.P.G., Sunu, P.W., Susila, N.D., Bangse, K., “The comparison of exhaust gas emission between conventional and electronic fuel injection system”, In: Proceedings of the International Conference on Innovation in Science and Technology (ICIST 2020), pp. 364-368, Semarang, Nov. 2021.
Petrea, N D, Bujoreanu, C., “Importance of fuel injection system for low emissions, combustion noise and low fuel consumption”, IOP Conference Series. Materials Science and Engineering, v. 444, n. 4, 042020, Nov. 2018
Katijan, A., Latif, M.F.A., Zahmani, O.F., Shahid Zaman, S., Kadir, K. A., Veza, I., “An experimental study for emission of four stroke carbureted and fuel injection motorcycle engine”, Journal of Advanced Research in Fluid Mechanics and Thermal Sciences, v. 62, n. 2, pp. 256-264, Oct. 2019.
Bhowmick, G., Sahoo, T., Bhat, A., Mathur, G., Gambhir, D., “Approach for CO2 reduction in India’s automotive sector”, SAE Technical Paper, no. 2019-28-2388, Nov. 2019.
Setiyo, M., Utoro, L., “Remapping engine control unit (ECU) untuk menaikan unjuk kerja mesin sepeda motor”, Jurnal Mesin Teknologi (SINTEK Jurnal), v. 11, n. 2, pp. 62–68, Des. 2017.
Adiyasa, W., Yudianto, A., Kurniadi, N., Sutiman, “Applied programmable ECU on an internal combustion engine single cylinder 600 cc for Student Formula Japan”, Journal of Physics: Conference Series, v. 1273, 012065, No. 2019.
Bigoš, P., Puškár, M., “Increasing of power output of racing motorcycle engine using of exhaust system optimisation”, Acta Mechanica Slovaca, v. 15, n. 1, pp. 71-77, Mar. 2011.
Rahmad, H., Sasongko, M.N., Widjayanti, W., “Pengaruh prosentase etanol terhadap torsi dan emisi motor indirect injection dengan memodifikasi engine control module”, Jurnal Rekayasa Mesin, v. 7, n. 2, pp. 49-54, Agu. 2016.
Manivannan, P., Ramesh A., “Development of a system for control of air fuel ratio in a small two wheeler engine”, SAE Technical Paper, no. 2008-28-0054, Sep. 2008.
Badrawada, I.G.G., Susastriawan, A.A.P., Pambudi, A., “ Pengaruh Electronic Control Unit Racing dan jenis bahan bakar terhadap performa sepeda motor 1 silinder 4 langkah”, Jurnal Teknologi, v. 13, n.2, pp. 144-147, Des. 2020.
Afwan, M.A., Rahardjo, W.D., “Pengaruh penggunaan ECU standard an ECU Juken dengan variasi injektor terhadap torsi dan daya sepeda motor Yamaha V-ixion”, Automotive Science and Education Journal, v. 9, n. 1, pp. 25-30, Des. 2020.
Tristanto, V., Paryono, & Sumarli, “Pengaruh penggunaan injektor Vixion dan ECU Racing pada sepeda motor Yamaha Mio J terhadap daya motor”, Jurnal Teknik Mesin, v. 24, n. 2, pp. 1-10, Des. 2016.
Amaral, A.A.D., Saidatin, N., Mahmud, R., Rohmawati, I., “Pengaruh ECU (Electronic Control Unit) dan variasi tipe jumlah hole injector terhadap performa engine single cylinder 4 langkah”, In: Seminar Nasional Teknologi Industri Berkelanjutan II (SENASTITAN II), pp. 373-378, Surabaya, Mar. 2022.
National Environmental Agency, Reducing pollution from in-use vehicles to achieve better air quality, https://www.nea.gov.sg/media/news/news/reducing-pollution-from-in-use-vehicles-to-achieve-better-air-quality. Diakses: Januari 2022.
Shah, J., & Bhaopichitr, K., Thailand: reducing emissions from motorcycles in Bangkok, In: World Bank Energy Sector Management Assistance Programme (ESMAP) Report, World Bank, Washington, D.C., 2003.
Rusdiani, R.R., Kajian faktor emisi kendaraan bermotor bahan bakar gasolin roda dua di kota Surabaya, Master Tesis, Institut Teknologi Sepuluh Nopember, Surabaya, Indonesia, 2018
Chemonics International, Vehicle emissions testing component: motorcycle emissions. Cairo Air Improvement Project Report, USAID, Cairo, 2020.
Al-Arkawazi, S.A.F.,” Analyzing and predicting the relation between air–fuel ratio (AFR), lambda (λ) and the exhaust emissions percentages and values of gasoline-fueled vehicles using versatile and portable emissions measurement system tool”, SN Applied Sciences, v. 1, pp. 1370, Okt. 2019.
Rossi, S., Buccarello, A., Malvezzi, C.C., Pinelli, S., Alinovi, R. Gerboles, A.G., Rozzi, G., Leonardi, F., Bollati, V., De Palma, G., Lagonegro, P., Rossi, F., Lottici, P.L., Poli, D., Statello, R., Macchi, E., Miragoli, M., “Exposure to nanoparticles derived from diesel particulate filter equipped engine increases vulnerability to arrhythmia in rat hearts”, Environmental Pollution, v. 284, pp. 117163, Sep. 2021,
Ioannis, M., Elisavet, S., Agathangelos, S., Eugenia, B., “Environmental and health impacts of air pollution: A review”, Frontiers in Public Health , v. 8, article no. 14, Feb. 2020.
Chen, S.L., Chang, S.W., Chen, Y.J., Chen, H-L,” Possible warming effect of fine particulate matter in the atmosphere”, Communications Earth & Environment, v. 2, no. 208, Okt. 2021.
Fushimi, A., Kondo, Y., Kobayashi, S., Fujitani, Y., Saitoh, K., Takami, A., Tanabe, K., “Chemical composition and source of fine and nanoparticles from recent direct injection gasoline passenger cars: Effects of fuel and ambient temperature:, Atmospheric Environment, v. 124, pp. 77-84, Jan. 2016.
Raza, M., Chen, L., Leach, F., Ding, S., “A review of particulate number (PN) emissions from gasoline direct injection (GDI) engines and their control techniques”, Energies, v. 11, n. 6, pp. 1417, Jun. 2018.
Yi, H., Seo, J., Yu, Y.S., Lim, Y., Lee, S., Lee, J., Song, H., Park, S., “Effects of lubricant-fuel mixing on particle emissions in a single cylinder direct injection spark ignition engine”, Scientific Reports, v. 12, no. 18, Jan. 2022.
Downloads
Published
Issue
Section
License
Copyright (c) 2023 Arka Dwinanda Soewono, Marten Darmawan, Josep Halim
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
