Rancang Bangun Mesin Pengiris Talas Semir

Wahyu Sugandi, Asep Yusuf, Ahmad Thoriq

Abstract


Talas semir is a superior commodity in Sumedang. Talas semir can be made into various type of snacks such as chips. The best quality of Talas semir chips can be produced by using the best cutting machine. Based on some experimental results of the cutting machine for producing talas semir chips, the design of cutting machine was not ergonomic. The machine was uncomfortable to be operated. This study aims to designing and creating the ergonomic cutting machine for producing talas semir chips. This machine consists of cutter, operator seat, product holder, axis of cutter disk, electric motor and transmission systems including belt and pulley. Based on the experiment, the theoretical and actual machine capacity are 47 kg/jam and 38 kg/jam, respectively. Whereas, the efficiency of this machine is 81%. By using this machine, the best quality of talas semir chips is produced aproximately 80% and 530 watt power is required.


Keywords


Talas Semir; Sumedang; Cutting Machine; Talas Semir Chips

Full Text:

PDF

References


Koswara, Sutrisno. 2013. Teknologi Pengolahan Umbi-Umbian Bagian 1: Pengolahan Umbi Talas. Bogor: Southeast Asian Food And Agricultural Science And Technology (SEAFAST)

Bapppeda Sumedang. 2005. RPJPD Kabupaten Sumedang 2005 – 2025. Badan Perencanaan Daerah Kabupaten Sumedang.

Apriani Rd.R.N, Setyadjit. Aprah, M. 2011. Karakteristik Empat Jenis Umbi Talas Varian Mentega, Hijau, Semir, dan Beneng Serta Tepung Yang Dihasilkan Dari Keempat Varian Umbi Talas. Jurnal Ilmiah Dan Penelitian, No.1 Vol.1 Retrieved from https://jurnaldanmajalah.wordpress.com/2011/01/04/6/

Gasni D. 2007. Karakteristik mesin pemotong ubi talas dengan mekanisme engkol peluncur. Jurnal TeknikA 2(27) : 62 – 68

Sholeh M., Pratama G.H., Pratama H.Y., dan Apair R.Y. 2012. Rancang Bangun Prototype Pengiris Umbi. Koswara, S. 2013. Pengolahan Umbi Talas. Southeast Asian Food and Agricultural Science and Technology (SEAFAST) Centre Research and Community Service Institution, Bogor Agricultural university.

Sularso dan Kiyokasu, Suga. 1997. Dasar Perencanaan dan Perancangan Elemen Mesin. Cetakan Kesembilan.Pradnya Paramita. Jakarta.

Singer, F. L., Andrew, P. and Darwin, S. 1995. Kekuatan Bahan (Teori kokoh_strenght of Material). Edisi Ketiga. Erlangga. Jakarta.




DOI: http://dx.doi.org/10.21776/ub.jrm.2017.008.02.3

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.